November 22, 2009 Fabio (Fabio66) said:
After a couple of years of meditation, the articles on Stephen Soriano Iddu and testing of rifles Itio, I have finally !!!!!
I began the transformation of my prototype Barracuda 100 double slings. The There are not many changes to make the mass and the profile remains the same, in fact this model my intention is to mount a rod of 7.5 mm max and I do not think that I will use an 8 mm.
stages of processing were as follows:
1) Cut the elevators that lifted the tires;
2) Cut the front hole and bending the tip;
3) hole for the pivot of the pulley
4) Milling points of contact of tire with the stem, the first 40 cm from the tip of the stem;
5) Forum for the housing of the lock ring on the belly of the gun;
6) Resin and paint.
Some images:
size from here and beyond here the rasp Barraruda-Roller 95, Roller pretensioned "rubber 16 mm 100 cm long. Equipment auction with 7 x 140 (per hour then a 7.5 x 125/130). The gum is also a certain tension reached the end of race tires (up to the pulleys). To upload you must provide a small stainless steel hook attached to a lanyard that you can keep the wrist, once hooked the dyneema you pull up to take one end of the round, then the procedure is classical.
View from above:
Viewed from the side (general):
Side view detail positioning circular
Seen in:
View over:
particular magazine:
now lacks the baptism of water, although I think I used the eraser is not progressive enough (soft), we'll see. Sunday I should try it.
0 comments:
Post a Comment