April 29, 2009 Massimiliano (astaincastrata) said: A 'INFORMATION:
your opinion, which is the best method to attack the carbon blade to the shoe? Black Silicon or other? Thanks Massimiliano
April 29, 2009 Vincenzo (cernia74) said:
to attack the liner Black Silicon
April 29, 2009 Fabio (Fabio66) said:
I have a shovel in the C4 carbon is on me for about three years with only compound to the suit, without even the steel pins in place of which I have used simple plastic ties. The other blade is detached me the other season and I put the black silicone.
29 April 2009 Claudio (furcix) said:
Hello everyone, I
the carbon fiber blades I have ever made with silicon, particularly those long in 835 carbon Apnea (those with whom we do the races) and I They never unglued, they do on the sole under the shoe.
's all about:
- clean up oily residues from the shoe mold
- do not touch the parts with sweaty or greasy hands
- clean the "T" that goes embedded in the spar
- clean inside
spars - a fundamental right to clean the blades and in the case, with sandpaper to give a slight cartatina 800/1000 water (be careful not exuberance!)
- Before the silicone portion must always check to be stuck in the longeron , because it could tory longer (they do on purpose to cover several models of shoes)
Bonding:
- put the silicon in the channel of the frame member (Without exaggerating, just a little and move forward ...)
- Fit the nozzle of the gun in the Silicon fianle near the heel of the shoe and put the silicon in a uniform manner
- put silicone in part under the shoe (where then go to support the final part of the blade)
- insert the blade and fit it properly in the side members and end of the shoe seems, do without the rubber folds
- Keep + foot blade joined together for two days with paper tape off about 40mm (conducted 4 / 5 turns of tape that must start from the beginning to the end where the spar, the blade stops and starts with water rails) in a place not exposed to light
- after two days Remove the tape slowly, and proceed to seal esternamete, always with silicone blade + shoe in visible parts
- model with the finger oiled enalogico Vaseline or oil, the bead profile that just made aete
Score:
- Pala perfectly welded to the shoe
- maximum bending without breaking points due to the holes
- smooth movement of the blade spars with
I have always done that, then ..... you do! Hello
April 29, 2009 Massimo (Fork) said:
better than this one can not describe, very good.
